Filter
Top Products
Greensmaster eFlex 1800/2100Page 6 -- 6Cutting Unit
Special Tools
Some special tools may have been supplied with your
mower or are available as TORO parts. O rder special
tools from your Toro Distributor. Some tools may also be
available from a local supplier.
Gauge Bar Assembly
Toro Part Number: 13--8199
Used to verify height--of--cut.
Figure 6
Backlapping Brush Assembly
Toro Part Number: TOR299100
Used to apply lapping compound to cutting unit while
keeping the operator’s hands ata safe distancefrom the
rotating reel.
Components for the brush assembly are available indi-
vidually as follows:
Brush 36--4310
Handle 29 --9080
Handle cap 2410--18
Figure 7
Bedknife Screw Tool
Toro Part Number: TOR510880
This screwdriver--type bit is made to fit Toro bedknife at-
taching screws. Use this bit with a 3/8” drive torque
wrench to secure the bedknife to the bedbar.
DO NOT use an air or manual impact wrench with this
tool.
Figure 8