Filter
Top Products
Greensmaster eFlex 1800/2100 Page 6 -- 17 Cutting Unit
3. Slide adjuster shaft (item 4) into flange bushings in
cutting unit side plate. Secure adjuster shaft with wave
washer (item 8 ) and retaining ring (item 9).
NOTE: Adjuster shaft (item 4) has left--hand threads.
4. Apply antiseize lubricant to threads ofbedbar adjust-
er screw (item 10) that fits into adjuster shaft. Thread
bedbar adjuster screw into adjuster shaft.
5. Install bedbar (see Bedbar Installation in this sec-
tion).
6. Install washer (item 11), spring (item 2) and lock nut
(item 3) onto adjuster screw. Tighten the lock nut on
each bedbar adjuster assembly until the compression
spring is fully compressed, thenloosen lock nut 1/2 turn.
7. Adjust cutting unit (see Cutting Unit Operator’s
Manual).
1. Crossmember
2. Detent
3. Cap screw
Figure 24
1
23
eFlex 1800 Shown
Cutting Unit