Filter
Top Products
Greensmaster eFlex 1800/2100 Page 1 -- 3 Safety
While Operating
1. Always stand behind the handle when starting and
operating the machine.
2. To begin machine op eration:
A. Make sure that the machine wire harness is con-
nected to the battery pack
B. Verify that the control lever on handle is in NEU-
TRAL position for both traction and reel drives.
C. Move key switch to START position until the Info
Center display lights up, then release switch to the
RUN position.
3. Before leaving the operator’s position of the mower:
A. Stop the machine on level ground.
B. Disengage both the traction and reel drives with
the control lever and set the parking brake.
C. Move key switch to OFF position and wait for all
machine motion to stop.
4. Before emptying basket ofclippings, disengage trac-
tion and reel drives, set the parking brake, move key
switch to OFF positionand wait for electric motorto stop.
Wait for all machine motionto stop before removing bas-
ket.
5. If the cutting unit strikes a solid object or vibrates ab-
normally, stop machine operation immediately. Disen-
gage the traction/mow lever, turn key switch to OFF
position, wait for all machine motion to stop. Then, dis -
connect battery pack (see Battery Pack Connection in
this section) and inspect cutting unit for damage. A dam-
aged reel or bedknife must be repaired or replaced be-
fore operation is commenced.
6. Whenever machine is left unattended, be sure elec-
tric motor is stopped, cutting unit reel is not s pinning and
key switch is in the OFF position. Remove key from
switch.
Maintenance and Service
1. The Traction Unit and Cutting Unit Operator’s Manu-
als provide information regarding the operation, general
maintenance and maintenance intervals for your
Greensmaster machine. Refer to these publications for
additional information when servicing the machine.
2. Before servicing or making adjustments to the ma-
chine, set the parking brake, move key switch to OFF
position and waitfor all machine motionto stop. Remove
key from the ignition switch. Disconnect battery pack
(see Battery Pack Connection in this section) to prevent
unintentional machine operation.
3. To make sure entire machine is in good condition,
keep all nuts, bolts, screws and belts properly tightened.
4. To reduce potential fire hazard, keep the battery
pack, electrical connectors, cutting unit and drive com-
ponents free of debris.
5. Wear heavy gloves and use caution when checking
or servicing the cutting unit.
6. If the electric motor must be running toperform main-
tenanceor make an adjustment, keep hands, f eet, cloth-
ing and all parts of the body away from the cutting unit
and all moving parts. Keep bystanders away.
7. Before installing, removing or working on the cutting
unit, disconnect the battery pack (seeBatteryPackCon-
nection in this section) to prevent unintentional machine
operation.
8. Do not open or alter the battery pack in any way.
Opening the battery packmay expose you to dangerous
electrical voltage. The warranty will be voided if you at-
tempt to open the batterypack. With the exception of the
battery pack fuse, fuse cover and labels, there are no
consumer serviceable parts on or in the battery pack.
9. If there ever is a need to ship the battery pack from
your eFlex machine, you will need special packaging to
comply with shipping regulations. Refer to the Operat-
or’s Manual for additional battery shipping information.
10.If major repairs are ever needed or assistance is re-
quired, contact your Authorized TORO Distributor.
11.At the time of manufacture, the machine conformed
to all applicable safety standards. To assure optimum
performance and continued safety certification of the
machine, use genuine Toro replacement parts and ac-
cessories. Replacement parts and accessories made
by other manufacturers may result in non-conformance
with safety standards and the warranty may be voided.
Safety