Filter
Top Products
Greensmaster eFlex 1800/2100 GroomerPage 7 -- 15
8. Loosen c ap screws (item 7) that secure front roller
shaft to groomer arms.
9. Remove lock nut and spring washer that secure RH
groomer arm lift rod toRHdriveplateassembly (Fig. 14).
10.Remove HOC nut (item 2), HOC washer (item 9) and
plow bolt (item 31) that secure RH groomer arm assem-
bly to RH drive plate assembly. Do not change height--
of--cut screw adjustment. Remove RH groomer arm
assembly from cutting unit.
11.Remove front roller from cutting unit.
NOTE: To prevent grooming reel shaft from turning
when removing driven pulley, use wrench on shaft flats
to hold shaft.
12.Remove the lock nut (item 15) that secures driven
gear (item 14) to grooming reel shaft. Remove driven
gear from shaft.
NOTE: To prevent cutting reel from turning when re-
moving groomer drive gear, use a 1/2” socket on hex of
reel drive shaft that is used for backlapping the cutting
reel.
13.Loosen and remove groomer drive gear (item 1 7)
from the cutting reel shaft.
14.Remove four (4) button head screws (item 30) that
secure the RH drive plate assembly (item 12) to the sup-
port plate on the cutting unit frame. Remove the RH
drive plate assembly from grooming shaft and cutting
unit.
15.Carefully pull the grooming reel from the LH support
plate.
16.Inspect seals, bushings and bearings in RH drive
plate, LH support plate and groomer arms for wear or
damage. Also, inspect gears and idler components for
wear or damage. Replace components as needed.
Installation (Fig. 11)
1. Apply a light coating of grease to ends of grooming
reel shaft and also to seal lips in RH drive plate and LH
support plate. Make sure that all bearings, bushings and
seals are properly installed.
2. Make sure that O--ring (item 11) is installed on
grooming reel shaft. Apply light coating of grease t o O--
ring.
3. Carefully place grooming r eel assembly into the LH
support plate taking care to not damage seal in support
plate or O--ring on shaft.
1. Extension spring
2. 43T idler gear
3. 47T idler gear
4. Groomer drive gear
Figure 12
4
2
1
3
1. RH drive plate assy
2. Flange nut
3. 43T gear/bearing
4. 47T gear/bearing
Figure 13
3
1
2
4
120 in --lb
(13.5 N--m)
1. Roller cap screw
2. Grooming reel assembly
3. Lock nut
4. Spring washer
5. Groomer arm lift rod
Figure 14
4
2
1
3
5
Groomer