Filter
Top Products
Greensmaster eFlex 1800/2100Groomer Page 7 -- 6
Adjustments
CAUTION
Before working on the cutting unit, always turn
the key switch OFF and disconnect the battery
pack from the wire harness. This will prevent un-
expected machine operation.
NOTE: See the Groomer I nstallation Instructions for
adjustment procedures for the groomer on your
Greensmaster.
Height/Depth of Groomer Adjustment
NOTE: Grooming is performed above the soil level.
When adjusting groomer height/depth, groomer blades
should never penetrate the soil.
1. Parkmachineon level surface. Turnkeyswitch to the
OFF position and remove key from the switch. Make
sure the traction lever is in the NEUTRAL position.
2. Disconnect the battery pack (see Battery Pack Con-
nection in the General Information section of this chap-
ter).
3. Make sure rollers are clean a nd cutting reel is set to
the desired height--of--cut (see Cutting Unit Operator’s
Manual for cutting unit adjustment procedures).
4. Position the grooming reel to the lowered, grooming
position (Fig. 2).
NOTE: Improper or over--aggressive use of the groom-
ing reel (i.e. too deep or too frequent grooming) may
cause unnecessary stress on the turf leading to severe
greens damage. Use the groomer cautiously.
5. On one end of the grooming reel, measure the dis-
tance from the lowest tip of the groomer blade to the
working surface. Lift and turn height adjustment knob to
raiseorlowerthebladetip(Fig.2).Eachnotchonthe
adjustment knob changes the groomer height approxi-
mately 0.003 inch (0.08 mm).
6. Repeat step 4 on the opposite end of the groomer.
Then, recheck setting on the first side of groomer.
Height setting on both ends of groomer should be identi-
cal.
7. After groomer adjustment is completed, connect the
battery pack (see Battery Pack Connection in the Gen-
eral Information section of this chapter).
1. Height adjustment knob 2. Lock screw
Figure 2
2
1
FORWARD ROTATING GROOMER SHOWN