Filter
Top Products
Greensmaster eFlex 1800/2100Groomer Page 7 -- 8
Groomer Cover (Counter Rotating Groomer Drive)
On eFlex machines with the counter rotating groomer,
the groomer cover includes a handle which engages
and disengages the groomer drive. When the handle is
rotated toward the front of the machine, the groomer is
engaged.
Removal
1. Parkmachineon level surface. Turnkeyswitch to the
OFF position and remove key from the switch. Make
sure the traction lever is in the NEUTRAL position.
2. Disconnect the battery pack (see Battery Pack Con-
nection in the General Information section of this chap-
ter).
3. Make sure that handle on groomer cover is rotated
toward front of machine so that groomer drive is en-
gaged.
4. Remove groomer cover assembly from machine
(Fig. 5):
A. Remove five (5) flange head screws that secure
groomer cover assembly to RH drive plate.
B. Remove groomer cover assembly and gasket
from machine. Disc ard gasket.
5. If necessary, remove shaft from groomer cover (Fig.
6):
A. Loosen setscrew (item9) on topof shaft andslide
handle from shaft.
B. Remove retaining ring (item 8) and thrust washer
(item5)fromshaft.
C. Remove plunger detent (item 6) from groomer
cover.
D. Slide shaft out of groomer cover. Remove and
discard O--ring (item 4) from shaft.
6. Remove grease from inside groomer cover and RH
drive plate on cutting unit. Thoroughly clean and inspect
all groomer drive components.
1. Groomer cover assembly
2. Screw (5 used)
3. Gasket
4. Handle
Figure 5
3
1
2
4
1. Groomer cover
2. Plug
3. Shaft
4. O--ring
5. Thrust washer
6. Plunger detent
7. Cap screw
8. Retaining ring
9. Set screw
10. Handle
Figure 6
6
1
4
5
8
9
3
10
2
7
Antiseize
Lubricant
Loctite #242