Filter
Top Products
Greensmaster eFlex 1800/2100 GroomerPage 7 -- 19
2. Install LH support plate to left side of cutting unit:
A. Apply antiseize lubricant to threads of LH groom-
er arm lift rod.
B. Position support plate to cutting unit making sure
that LH groomer arm lift rod is positioned through
bushing in support p late.
C. Place spring washer and lock nut on lift rod
threads (Fig. 20). Tighten lock nut.
D. Install reel drive assembly, reel pulley, reel drive
belt and then reel drive cover to left side of cutting
unit (see ReelDrive Assembly in the Service and Re-
pairs section of Chapter 3 -- Traction and Reel Drive
System).
3. Install grooming reel, front roller and RH drive plate
to right side of cutting unit (see Grooming Reel (Forward
Rotating or Counter Rotating) in this section).
4. Check and adjust grooming reel height and mower
height--of--cut s ettings.
5. Install cutting unit to the machine.
6. Lubricate groomer bearings.
7. Connectthe battery pack(see Battery Pack Connec-
tion in the General Information section of this chapter).
NOTE: After greasing groomer bearings, operate
groomer for 30 seconds, stop machine and wipe any ex-
cess grease from groomer shaft and seals.
1. RH drive plate assy
2. Bearing (2 used)
3. Seal (2 used)
Figure 22
3
1
2
2
3
Seal lips
(toward center of
cutting unit)
COUNTER ROTATING GROOMER
1. LH support plate
2. Bearing
3. Seal
4. Plug
Figure 23
Seal lip
(toward center of
cutting unit)
3
2
4
1
1. Outer bearing
2. Drive plate shoulder
3. Inner bearing
4. Inner race
5. Seal lip
6. Support plate bearing
7. Drive plate (RH side)
8. Support plate (LH side)
Figure 24
1
2
3
4
5
5
5
6
7
8
Groomer