Tektronix AWG510 Portable Generator User Manual


 
Removal and Installation Procedures
AWG510 & AWG520 Service Manual
6-31
J932
J931
J930
A10/A11 Connector Board
Figure 6-12: Fan removal
1. Assemble equipment and locate modules to be removed:
a. Have handy a screwdriver with a size Phillips #2 tip (Items 1 and 3), and
if removing the disk drive main body, Phillips #1 head (Items 2).
b. Locate the modules to be removed, including those listed under
Additional Modules Removed in the locator diagram Outer-Chassis
Modules, Figure 6–3, page 6–14.
c. Do the procedure Trim Ring, Menu Buttons, and Output Panel (page
6–23).
2. Orient the waveform generator: Set the generator so its top is down on the
work surface and its left side is facing you.
Floppy Disk