Filter
Top Products
Removal and Installation Procedures
AWG510 & AWG520 Service Manual
6-11
Equipment Required. Most modules in this generator can be removed with a
screwdriver with a size #2, Phillips tip. Use this tool whenever a procedure step
instructs you to remove or install a screw unless a different size screwdriver is
specified in that step. All equipment required to remove and reinstall a module
are listed in the first step of each procedure.
Table 6-4: Tools required for module removal
Item
No.
Name Description
Tektronix Part
Number
1 Screwdriver handle Accepts Phillips-driver bits
2 #1 Phillips tip Phillips-driver bit for #1 screw size
3 #2 Phillips tip Phillips-driver bit for #2 screw size
4 Flat-blade screwdriver Screwdriver for removing standard-
headed screws
5 Needle-Nose Pliers Standard tool
6 Nutdriver,
1
@
2
inch Standard tool
7 Nutdriver, 5 mm Standard tool
8 Nutdriver, 7 mm Standard tool
9 Retaining Ring Pliers Standard tool
10 AngleĆTip Tweezers Standard tool
11 Soldering Iron Standard tool
12 Pliers Standard tool
13 Solder Wick Standard tool
14 Adhesive TRAĆCON: TraĆBond #BAĆ2114