Installed Software 81
E-EQ-HX2RG-B HX2 Reference Guide
Wavelink Avalanche Enabler
Related Manual: Using Wavelink Avalanche on LXE Windows Computers.
The following features are supported by the Wavelink Avalanche Enabler when used in
conjunction with the Avalanche Manager. After configuration, Enabler files are installed upon
initial bootup and after a hard reset. Network parameter configuration is supported for:
• IP address: DHCP or static IP
• RF network SSID
• DNS hosts (primary, secondary, tertiary)
• Subnet mask
• Enabler update
The HX2 has the Avalanche Enabler installation files loaded, but not installed, on the mobile
device when it is shipped from LXE. The installation files are located in the System folder on CE
devices. The installation application must be run manually the first time Avalanche is used.
After the installation application is manually run, a reboot is necessary for the Enabler to begin
normal performance. Following this reboot, the Enabler will by default be an auto-launch
application. This behavior can be modified by accessing the Avalanche Update Settings panel
through the Enabler Interface. The designation of the mobile device to the Avalanche CE Manager
is LXE_HX2.
See Wavelink Avalanche Enabler Configuration at the end of this chapter for instruction.
If the user is NOT using Wavelink Avalanche to manage their mobile device, the Enabler
should not be installed on the mobile device(s).
