Setup a New Device 227
E-EQ-HX2RG-B HX2 Reference Guide
Setup a New Device
Prerequisites:
• The touch panel must be enabled.
• All “normal” keys must be identified/available by the System Administrator. See Chapter 2
– Physical Description and Layout, section titled Keypad.
• See Creating Hotkey and Switch Key Sequences later in this chapter.
• An HX2 default input method (Input Panel, Transcriber, or custom input method) is
assigned.
LXE CE devices with the AppLock feature are shipped to boot in Administration mode with no
default password, thus when the device is first booted, the user has full access to the device and no
password prompt is displayed. After the administrator specifies an application to lock, a password
is assigned and the device is rebooted or the hotkey is pressed, the device switches to end-user
mode.
Briefly, the process to configure a new device is as follows:
1. Insert a fully charged battery and press the Power button.
2. Adjust screen display, audio volume and other parameters if desired. Install accessories, if
necessary.
3. Tap Start | Settings | Control Panel | Administration icon.
4. Assign a Switch Key (hotkey) sequence for AppLock. See Security Panel.
5. Assign an application on the Application tab screen. More than one application can be
assigned on the Application tab screen. See Application Panel.
6. Assign a password on the Security tab screen. See Security Panel.
7. Select a view level on the Status tab screen, if desired. See Status Panel.
8. Tap OK.
9. Press the hotkey sequence to launch AppLock and lock the configured application(s). If the
Dual Alpha or Triple Tap keypad are in use, the AppLock default Administrator Hotkey
sequence (Shift+Ctrl+A) must be modified.
10. The device is now in end-user mode.
Note: AppLock cannot support multiple windows of some applications. Attempting to open
multiple windows of RFTerm or Pocket Word will cause AppLock to switch to
administration mode.
