Assembly 23
E-EQ-HX2RG-B HX2 Reference Guide
Slipping the HX2 into the Voice Case
The voice case is a sturdy, lightweight covering for the HX2, tethered battery, and voice
accessories. The voice case cannot protect the HX2 from destructive, excessive force or a harsh or
wet environment. It is designed to protect the HX2 from dirt, dampness, and minor, trivial bumps.
Figure 1-24 HX2 Voice Case
1. Slide the belt through the belt loop on the voice case. Do not put the belt on yet.
2. Attach the battery cable, ring scanner and audio device to the HX2.
3. Slip the HX2 into the voice case. Be sure the screen and keypad are visible through the clear
window of the voice case.
4. Slide the battery cable through the protective loop at the bottom of the voice case. Make sure
the tethered cable for the ring accessory is on the outside of the voice case.
5. Slip the battery into the battery sleeve and connect the battery to the battery cable. The battery
charge terminals (small metallic circles) should always be covered by the sleeve.
6. Press the hook and loop fabric at the top of the device together.
7. The HX2 in the Voice Case is ready for use.
8. Put the belt on. Adjust the belt and voice case for comfort.
Examine the tethers and the hook and loop fabric fastening periodically. If any are loose or
unfastened, tighten the tethers and the top fastener before placing the voice case back into service.
If the voice case is damaged, it should be removed from service.
Note: The HX2 with a voice case does not fit in the HX2 cradle. Remove the voice case before
placing the HX2 in a charged cradle.
