120 Settings | Control Panel Options
HX2 Reference Guide E-EQ-HX2RG-B
Password
Access: | Settings | Control Panel | Password Icon
Set HX2 user access/power up password properties. Password and password settings are saved
during a warm boot and a cold boot. The screensaver password affects the Remote Desktop
screensaver only.
Factory Default Settings
Password Blank
Enter at Power On Disabled
Enter at Screen Saver Disabled
Note: Once a password is assigned, each Settings option requires the password be entered
before each Settings option can be accessed.
Figure 3-33 Password
Enter the password in the Password textbox, then type it again to confirm it.
Enable the power-on checkbox and, if desired, the screensaver checkbox. Tap the OK button to
save the changes. The password is in effect immediately.
The screensaver password is the same as the power-on password. They are not set independently.
A screensaver password cannot be created without first enabling the Enable password protection
at power-on checkbox. The screensaver password is not automatically enabled when the Enable
password protection at power-on checkbox is enabled.
Troubleshooting – Passwords
The password must be entered before performing a cold boot or cold reset. If entering a power-on
or screensaver password will not allow you to disable password protection or run COLDBOOT,
contact LXE Technical Support.
