A SERVICE OF

logo

COM1 Tab 163
E-EQ-HX2RG-B HX2 Reference Guide
Parameter Function
Imager LED
Illumination
The default setting is Internal illumination. The imager has a bank of
three LEDs above the imager aperture that illuminate when External or
Both radio buttons are enabled. The illumination turns off when the
scan is complete.
COM1 Tab
Access: | Settings | Control Panel | Scanner | COM1 tab
Factory Default Settings
COM1 Port (cradle serial port)
Baud Rate 9600
Stop Bits 1
Parity None
Data Bits 8
Figure 4-3 Scanner Control / COM1
If these values are changed, the default values are restored after a cold boot or reflashing.