36 Bluetooth
HX2 Reference Guide E-EQ-HX2RG-B
Note: After scanning the HX2 Bluetooth label, if there is no beep and no LED flash from the
Bluetooth device, the devices are currently paired.
HX2 without Label
If the HX2 Bluetooth address barcode label does not exist, follow these steps to create a unique
Bluetooth address barcode for the HX2:
First, locate the HX2 Bluetooth address by tapping Start | Settings | Control Panel | Bluetooth |
About tab.
Figure 1-31 About tab and Bluetooth Address
Next, create a Bluetooth address barcode label for the HX2
4
.
The format for the barcode label is as follows:
• Barcode type must be Code 128.
• FNC3 character followed by string Uppercase L, lowercase n, lowercase k, uppercase B
and then the Bluetooth address (12 hex digits, no colons). For example,
LnkB0400fd002031.
Create and print the label.
Scan the HX2 Bluetooth address barcode label with the mobile Bluetooth barcode reader.
The devices are paired. The Bluetooth barcode reader responds with a series of beeps and LED
flashes. Refer to the following section titled Bluetooth Beep and LED Indications.
Note: After scanning the HX2 Bluetooth label, if there is no beep and no LED flash from the
mobile Bluetooth device, the devices are currently paired.
Bluetooth Beep and LED Indications
The following indications relate to the behavior of the mobile Bluetooth scanner, not the HX2.
Beep Type Behavior
1 beep Acknowledge label
2 beeps at low frequency Label rejected
Beep will sound high-low-high-low Transmission error
Beep will sound low-medium-high Link successful
Beep will sound high-low-high-low Link unsuccessful
4
Free barcode creation software is available for download on the world wide web. Search using the keywords
“barcode create”.
