Factory Default Settings 161
E-EQ-HX2RG-B HX2 Reference Guide
Factory Default Settings
Factory Default Settings
Main
Port 1 Disabled until auto-detect
Port 2 Disabled until auto-detect
Port 3 Disabled until auto-detect
Send key messages (WEDGE) Enabled
Enable Scanner Sound Enabled
Imager LED Illumination Internal
COM1 Port (cradle serial port)
Baud Rate 9600
Stop Bits 1
Parity None
Data Bits 8
Barcode
Enable Code ID None
Port 1 defaults to Bluetooth and Port 2 defaults to Ring when a Bluetooth enabled HX2 with ring
scanner/imager is powered On by the user. See the figure below for an example.
Figure 4-1 Scanner Control Panels
If Send Key Messages … is checked any data scan is converted to keystrokes and sent to the
active window. When this box is not checked, the application will need to use the set of LXE
Scanner APIs to retrieve the data from the scanner driver. Note that this latter method is
significantly faster than using Wedge.
Disable Enable Internal Scanner Sound when you want an application, not the Bluetooth scan
engine or the CE operating system, to control scanner audible notifications. Adjust the settings
and tap the OK box to save the changes. The changes take effect immediately.
