Strap Assemblies 49
E-EQ-HX2RG-B HX2 Reference Guide
Strap Assemblies
Caution: Do not perform the following procedures if the ring barcode reader is tethered to the
HX2. There is a possibility the Scan button may be pressed inadvertently and the laser beam
emitted.
LXE recommends that installation or removal of accessories be performed on a clean, well-lit
surface. When necessary, protect the work surface, the mobile device, and components from
electrostatic discharge.
Note: Do not touch, push on or brace your finger against the scan aperture at any time.
Removing / Replacing the Ring Finger Strap Assembly
Note: Do not pull on the finger strap or the flexible liner to remove the finger strap assembly.
This quick disconnect function is designed for occasional safety hazards and is not
intended for daily removal.
A 20 pak of Ring Scanner Finger Straps is available from LXE (8600A401RINGSTRAP). See
Accessories.
Using the Quick Disconnect Function, grasp the finger strap and pull the finger strap out and
away from the ring scanner.
Before attaching the finger strap to the trigger module, thread the finger strap, warning label side
down, first through the hinge, then under and over the pin next to the scan button.
It should slide easily.
Removing / Replacing the Trigger Module
Equipment Needed: Phillips screwdriver with a blade diameter of 1/8” (.4mm). Not supplied by
LXE.
LXE recommends that installation or removal of accessories be performed on a clean, well-lit
surface. When necessary, protect the work surface, the mobile device, and components from
electrostatic discharge.
A 20 pak of full Trigger assemblies is available from LXE (8600A403TRIGGERKIT). See
Accessories.
Remove Finger Strap Assembly
Original finger strap assemblies – Remove the flexible liner from the finger strap assembly and
discard the flexible liner.
Version 2 finger strap assemblies – Fold the flexible liner back until the screw hole is visible.
1. Rotate the trigger module until the black screw is visible as shown in the following
figure.
2. Using a Phillips screwdriver with a blade diameter of 1/8” (.4mm) loosen the black
screw counter-clockwise and set the screw aside in a safe place.
3. Remove the trigger module.
