188 Summit Client Configuration
HX2 Reference Guide E-EQ-HX2RG-B
Status Tab
This screen displays information on the current profile and wireless connection. Information
cannot be edited or changed on the Status panel.
or
Figure 5-6 SCU – Status Tab
The panel displays:
• Config / Profile being used.
• The client name, IP address and MAC address.
• The status of the network connection (down, associated, authenticated, etc.).
• The name, IP address and MAC address of the Access Point maintaining the connection to
the network.
• Channel currently being used for wireless traffic.
• Beacon period – The time between AP beacons in kilomicroseconds (1 kilomicrosecond =
1,024 microseconds).
• DTIM interval – A multiple of the beacon period that specifies how often the beacon
contains a delivery traffic indication message (DTIM). The DTIM tells power saving
devices a packet is waiting for them. For example, if DTIM = 3, then every third beacon
contains a DTIM.
• Current transmit power in mW.
• Rate in Mbps.
• Signal strength (RSSI) and signal quality (changes with network activity). Signal quality is
a measure of the clarity of the signal and is displayed as a percentage.
Note: After completing radio configuration, it is good practice to review this screen to verify
the radio has associated (no encryption, WEP) or authenticated (LEAP, any WPA), as
indicated above.