Bluetooth 37
E-EQ-HX2RG-B HX2 Reference Guide
LED Behavior
Yellow LED blinks at 2 Hz Linking in progress
Off Disconnected or unlinked
Yellow LED blinks at 50 Hz Bluetooth transmission in progress
Yellow LED blinks at the same rate
as the paging beep (1 Hz)
Paging
Green LED blinks once a second Disabled indication
Upon startup, if the mobile Bluetooth scanner sounds a long tone, this means the scanner has not
passed its automatic Selftest and has entered isolation mode. If the scanner is reset, the sequence is
repeated. Contact LXE Support for assistance.
Bluetooth Printer Setup
The Bluetooth managed device should be as close as possible, in direct line of sight, with the HX2
during the pairing process.
1. Open the LXEZ Pairing panel [Start | Settings | Control Panel | Bluetooth].
2. Tap Discover. Locate the Bluetooth printer in the discovery panel.
3. Tap and hold the stylus on the Bluetooth printer until the right-mouse-click menu appears.
4. Select Pair as Printer to pair the HX2 with the Bluetooth managed printer.
The devices are paired. The Bluetooth managed printer may respond with a series of beeps or
LED flashes.
Please refer to the Bluetooth managed printer manufacturer’s User Guide; it may be available on
the manufacturer’s web site. Please contact your LXE representative for Bluetooth product
assistance.
Note: If there is no beep or no LED flash from the Bluetooth managed printer, the HX2 and the
printer are currently paired.
