Setting Timers 45
E-EQ-HX2RG-B HX2 Reference Guide
Setting The Audio Speaker Volume
Note: An application may override the control of the speaker volume. Turning off sounds saves
power and prolongs battery life.
The internal speaker is located on the front of the device above the “2” key. The audio volume can
be adjusted to a comfortable level for the listener. Operational “beeps” are emitted from the
speaker. A Battery/Audio cable is available for headsets, see Accessories and Cables.
Using the Keypad
Note: Volume & Sounds (in Settings | Control Panel) must be enabled before the following
default key sequences will adjust the volume.
The volume is increased or decreased one step each time the volume key sequence is pressed.
To adjust speaker volume use the:
• Blue+Up Arrow and Blue+Down Arrow keys on the Alpha Mode 3 Tap keypad
• Orange+Diamond 1+Up Arrow and Orange+Diamond 1+Down Arrow keys on the
Dual Alpha and Triple Tap keypads
Until the speaker volume is satisfactory.
Using the Touchscreen
Tap | Settings | Control Panel | Volume & Sounds | Volume tab. Change the volume setting
and tap OK to save the change.
Figure 1-38 Volume & Sounds Properties
You can also select / deselect sounds for key clicks and screen taps and whether each is loud or
soft.
As the volume scrollbar is moved between Loud and Soft, the computer will emit a tone each time
the volume increases or decreases in decibel range.
See Chapter 3 – System Configuration for more information.
