162 Main Tab
HX2 Reference Guide E-EQ-HX2RG-B
Main Tab
Access: | Settings | Control Panel | Scanner | Main tab
Factory Default Settings
Main
Port 1 Disabled until auto-detect
Port 2 Disabled until auto-detect
Port 3 Disabled until auto-detect
Send key messages (WEDGE) Enabled
Enable Scanner Sound Enabled
Imager LED Illumination Internal
Figure 4-2 Scanner Control / Main
Adjust the settings and tap the OK box to save the changes. The changes take effect immediately.
Parameter Function
Port The ports are disabled until the HX2 auto-detects a device tethered to
the port. Port 1 defaults to Bluetooth and Port 2 defaults to Ring when a
Bluetooth enabled HX2 with ring scanner/imager is powered On.
Send Key Messages
(WEDGE)
When Send Key Messages (WEDGE) is checked any data scan is
converted to keystrokes and sent to the active window. When this
checkbox is not checked, the application will need to use the set of LXE
Scanner APIs to retrieve the data from the scanner driver. Note that this
latter method is significantly faster than using Wedge.
Enable Scanner
Sound
The default is Enabled. Functionality of the tethered scanner driver
engine includes audible tones on good scan (at the maximum db
supported by the speaker) and failed scan.
Disable this parameter when good scan/bad scan sounds are to be
handled by alternate means e.g. application-controlled sound files.
Rejected barcodes generate a bad scan beep. In some cases, the receipt
of data from the scanner triggers a good scan beep from a tethered
scanner, and then the rejection of scanned barcode data by the
processing causes a bad scan beep from the HX2 on the same data.
