A SERVICE OF

logo

Open as PDF
next previous
50 Strap Assemblies
HX2 Reference Guide E-EQ-HX2RG-B
Figure 1-41 Step 1 : Rotate Trigger Module and Remove Screw
Figure 1-42 Step 2 : Rotate Trigger Module again until it pops up. Remove the
trigger module.
Replace
1. Position the trigger module on the base of the Ring Scanner, making sure the empty screw
hole is visible as shown in the following figure.
2. Find the tiny black screw that you removed previously.
Figure 1-43 Replace Trigger Module
3. Using a Phillips screwdriver with a blade diameter of 1/8” (.4mm) rotate the black screw
clockwise until the trigger module is secured to the ring scanner.
4. Install the finger strap. See Removing / Replacing the Ring Finger Strap Assembly.