Filter
Top Products
80
3-2-05: OUTPUT
These parameters turn the “dry lines” (i.e. the signal paths which bypasses each
effect processor) on or off, determining whether any dry signal output can occur at
the OUTPUT.
PERFORMANCE EDIT MODE / 3: Full Edit. 3-2: Effect
3-2-05: OUTPUT
The layer to be edited is selected as described on page 50. The currently selected
layer is shown in square brackets on the upper display line.
Dry1
Range: off, on
Turns the “dry line” bypassing the EFFECT 1 signal processor on or off.
When this parameter is turned “off,” the “WET:DRY” parameters (page 154)
have no effect.
Dry2
Range: off, on
Turns the “dry line” bypassing the EFFECT 2 signal processor on or off.
When this parameter is turned “off,” the “WET:DRY” parameters (page 154)
have no effect.
[PLAY MODE] -> PFM PLAY -> [EDIT/COMPARE] -> 3: Full Edit -> [ENTER] -> 3-2:Effect -> [ENTER]
-> [PAGE] -> 3-2-05 : Output -> [ENTER]