Filter
Top Products
55
PERFORMANCE EDIT MODE / 1: QUICK EDIT
1-3: VOICE LFO OFFSET
1-3: VOICE LFO OFFSET
These parameters allow the main LFO parameters of the voices assigned to each
layer to be modified to some degree. The actual LFO parameters of the voices are not
affected. These “offset” values are only effective in the performance mode.
The layer to be edited is selected as described on page 50. The currently selected
layer is shown in square brackets on the upper display line.
Depth (LFO depth)
Range: -99 … +99
Modifies the amplitude, pitch, and frequency modulation depth of the LFO
(this corresponds to the “Pmod”, “Amod”, and “Fmod” parameters of the main
voice LFO — see page 138). Plus (+) values produce greater modulation depth
while minus (–) values reduce the modulation depth.
No matter how much offset is applied, the minimum and maximum LFO
depth values cannot be exceeded.
Speed (LFO speed)
Range: -99 … +99
Modifies the speed of the LFO (this corresponds to the “Speed” parameter
of the main voice LFO — see page 136). Plus (+) values increase the LFO
speed while minus (–) values reduce the speed.
No matter how much offset is applied, the minimum and maximum LFO
speeds cannot be exceeded.
[PLAY MODE] -> PFM PLAY -> [EDIT/COMPARE] -> 1: Quick Edit -> [ENTER] -> PAGE
-> 1-3 : Voice LFO -> [ENTER]