Filter
Top Products
233
UTILITY MODE / WAVE EDIT MODE / 4: Card
4-1: BANK
4-1: BANK
This function is used to select bank 1 or 2 of Yamaha MCD64 memory cards
plugged into the DATA 1 and DATA 2 slots.
Slot1, Slot2 (Slot 1 and slot 2 card banks)
Range: 1, 2
Each MCD64 memory card has two separate banks which are selected for
access via these parameters. The “Slot1” parameter selects bank 1 or 2 of the
card plugged into the DATA 1 slot, and the “Slot2” parameter selects bank 1
or 2 of the card plugged into the DATA 2 slot.
The format of the card plugged into the selected slot is indicated in paren-
theses in the upper right corner of the display. “TG500” indicates that the card
has been properly formatted for use with the TG500. “------” indicates that
either no card is inserted or the card is not formatted for use with the TG500.
New MCD64 memory cards, or cards that have been formatted for use with
other equipment, must first be formatted by using the “4-4: FORMAT” function
(page 236) before they can be used with the TG500.
[UTILITY/SELECT] -> 4: Card -> [ENTER] -> [PAGE] -> 4-1: Bank -> [ENTER]