Filter
Top Products
63
PERFORMANCE EDIT MODE / 3: Full Edit. 3-1: Layer
3-1-02: VOLUME
3-1-02: VOLUME
For optimum balance between the voices in a performance combination, this
screen allows the volume of each voice to be adjusted individually.
Volume (layer A)
The layer to be edited can be selected as described on page 50. The currently
selected layer is shown in square brackets on the upper display line.
Volume
Range: 0 … 127
Use the [ ] and [ ] keys (or the standard layer selection procedure) to select
the layer to be edited, then use the [-1/NO] and [+1/YES] keys to adjust the
volume levels of the voice assigned to that layer. A setting of “0” produces no
sound, while a setting of “127” produces maximum volume.
The name of the currently selected voice is shown in the upper right corner
of the display (“--------” appears if the voice is turned off). An animated musi-
cal note appears to the right of voices that are on and active (i.e. not muted).
[PLAY MODE] -> PFM PLAY -> [EDIT/COMPARE] -> 3: Full Edit -> [ENTER] -> 3-1:Layer -> [ENTER]
-> [PAGE] -> 3-1-02 : Volume -> [ENTER]