Filter
Top Products
203
MULTI EDIT MODE / 3: Initialize
INITIALIZE
3: INITIALIZE
When you want to program a totally new multi setup “from scratch,” rather than
editing an existing setup, use this function to initialize all multi parameters.
Press [ENTER] to begin the initialize procedure. The following confirmation
display will appear:
Press [+1/YES] to confirm that you want to go ahead with the initialize operation
(which will erase all current edited data), or press [-1/NO] to cancel.
“Completed!” will appear briefly on the display when the multi data has been
initialized.
See page 293 for initial multi parameters.
[PLAY/MODE] -> MLT PLAY -> [EDIT/COMPARE] -> [PAGE] -> 3: Initialize -> [ENTER]