Filter
Top Products
78
PERFORMANCE EDIT MODE / 3: Full Edit. 3-2: Effect
3-2-03: SEND
3-2-03: SEND
The parameters provided here determine to which of the TG500 effect stages the
output from the voice assigned to each layer is sent, and at what level.
2b
The layer to be edited is selected as described on page 50. The currently selected
layer is shown in square brackets on the upper display line.
Lvl (Send level)
Range: 0 … 127
This parameter adjusts the amount of direct voice signal that is sent to the
effect processors, determining the strength of the final effect sound. A setting
of “0” results in no effect, leaving only the “dry” sound of the voice. The
maximum setting of “127” produces the maximum amount of effect.
1a, 1b, 2a, and 2b (Send switches)
Range: See text below.
Determines to which of the EFFECT 1 and EFFECT 2 effect stages the
output from the current layer is sent. The [-1] and [+1] keys can then be used
to turn the selected stage on or off.
If a “single” type effect is selected then only stage “a” can be selected. If a
“dual” type effect is selected, then both stages “a” and “b” can be selected. An
effect stage that cannot be selected is represented by “---” on the display.
See the “EFFECTS” section beginning on page 251 for more details.
Lvl
1a
1b 2a
[PLAY MODE] -> PFM PLAY -> [EDIT/COMPARE] -> 3: Full Edit -> [ENTER] -> 3-2:Effect -> [ENTER]
-> [PAGE] -> 3-2-03 : Send -> [ENTER]