Control Panel Options 83
E-EQ-MX3RFIDRG-A MX3-RFID Reference Guide
RFID Configuration Utility
Access: Start | Settings | Control Panel | RFID
Note: Control Panel parameters established in Display Properties, Power Properties and
Volume & Sounds Properties remain in effect during RFID configuration and the
resulting read functions.
There are two versions of the RFID Configuration Utility.
The version presented in this chapter supersedes the version installed in earlier versions of the
MX3-RFID mobile device. Contact your LXE representative for availability of the previous or
current RFID CAB file.
Factory Default Settings
Tags
Tag Types to Read – Class 0 Enabled
Class 0 Tag Read Attempts 4
Tag Types to Read – Class 1 Enabled
Class 1 Tag Read Attempts 1
Class 0 Singulation ID 2
Tag Types to Read – C1G2 Enabled
C1G2 Tag Read Attempts 1
C1G2 Q-Value 3
Reader Output Preamble Blank
Reader Output Postamble Blank
Reader Output Separator ^M^J
Filters
Select Blank
Field Name Blank
Offset Blank
Mask Value Blank
Read
Read Once on Key Press Enabled
Read Continuous during Key Press Disabled
Toggle On/Off with Key Press Disabled
Beep Once on Tag Read Enabled
Buzz during Read Cycle Enabled
Send Key Messages (Wedge) Enabled
Power
Output Power +30 dBm
Modulation 95%
Power Management 3 sec
Disable Disabled
Firmware
File Blank
Format
HEX Enabled
EPC Disabled
Field Separator Blank
See Also: “Set the Display Backlight Timer”, “Set the Power Schemes Timers”, and “Set the
Audio Speaker Volume”.
