Cisco Client Configuration 163
E-EQ-MX3RFIDRG-A MX3-RFID Reference Guide
EAP-TLS Authentication Configuration
To authenticate using the EAP-TLS protocol you need a user certificate file and a private key file.
Once you have the user certificate files run the certificate installer from the Microsoft control
panel. For EAP-TLS it does not matter which Cisco cab file is installed.
Note: It is important that all dates are correct on the .NET computers when using any type of
certificate. Certificates are date sensitive and if the date is not correct authentication will
fail.
User Certificate
To check if a user certificate is installed navigate to Start | Control Panel | Certificates.
Set the drop down box to “My Certificates” as shown below.
The correct user certificate should be shown in the right pane.
Figure 4-46 Certificate Stores
Tap the View . . . button.
Figure 4-47 View Certificate Details
Set the Field to Private Key.
Make sure the private key is Present.
If it is not present, install the private key file.
