Control Panel Options 89
E-EQ-MX3RFIDRG-A MX3-RFID Reference Guide
Read
Access: Start | Settings | Control Panel | RFID | Read tab
Figure 3-14 RFID Configuration Utility – Read tab
Tap the Restore Defaults button to set the parameters to their factory default setting. Tap OK to
save changes or X to ignore any changes and return to the Control Panel.
Reader Key Action
When the “Toggle On/Off with key press” is enabled, the “’Buzz’ during Read Cycle” check box
is automatically enabled.
Read Once on Key Press
When the RFID Read button is pressed a single read operation is performed and the RFID reader
waits for another key press. The operation reads a combination of Class 0, Class 1 and C1G2 tags
depending on whether the class was selected on the Tags tab. The read for each tag class consists
of 1 or more internal read attempts as specified on the Tags tab.
Read Continuous During Key Press
When the RFID Read button is pressed, the MX3-RFID reads a combination of Class 0, Class 1
and C1G2 tags repeatedly until the Read button is released. The operation continuously reads a
combination of Class 0, Class 1 and C1G2 tags depending on whether the class was selected on
the Tags tab. The read for each tag class consists of continuous internal read attempts as specified
on the Tags tab.
Toggle On/Off with Key Press
When the RFID Read button is pressed, the MX3-RFID reads a combination of Class 0, Class 1
and C1G2 tags repeatedly. It continues to perform read operations after the Read button is released
and does not stop reading until the Read button is pressed again. The Read operation is cancelled.
The operation continuously reads a combination of Class 0, Class 1 and C1G2 tags depending on
whether the class was selected on the Tags tab.
