12 Getting Started
MX3-RFID Reference Guide E-EQ-MX3RFIDRG-A
Connect Audio Jack (Optional)
The audio jack is located on the endcap.
Figure 1-11 Connect Audio Jack
Insert the 2.5mm barrel end of the connector into the audio jack on the endcap and push the
connector in firmly. See section titled “Set the Audio Speaker Volume”.
Note: The audio option draws power from the battery. The speaker is disabled when a headset
is plugged into the audio jack.
Power Button
Note: Refer to the section titled “Power Modes” later in this chapter for information relating to
the power states of the mobile device.
Figure 1-12 Power Button
The power button is located above the ESC key on the keypad. When a battery is inserted in the
mobile device press the Power button.
Quickly tapping the Power button places the device immediately in Suspend mode. Quickly
tapping the Power button again, or touching the screen, immediately returns the device from
Suspend.
When the Windows desktop is displayed or an application begins, the power up (or reboot)
sequence is complete.
Please refer to the section titled “Power Modes” later in this guide for a list of the kinds of
activities (Primary Events) that will return the device from Suspend Mode.
Restart Sequence
Tap Start | Run, then type warmboot in the textbox and press Enter. If the touchscreen is not
accepting taps or needs recalibration, press <Ctrl>+<Esc> to force the Start Menu to appear.
When the Windows CE. NET desktop is displayed or an application begins, the power up (or
restart) sequence is complete. If you have previously saved your settings, they will be restored on
reboot.
Any RFID tag data retrieved and not saved is lost during a reboot or reset.
