78 Control Panel Options
MX3-RFID Reference Guide E-EQ-MX3RFIDRG-A
Password
Access: Start | Settings | Control Panel | Password Icon
Set user access and power up password properties.
Factory Default Settings
Password Blank
At Power On Disabled
Note: Once a password is assigned, each Control Panel option requires the password be
entered before the Control Panel option can be accessed. If you forget the password, it
cannot be restored without performing a cold boot on the unit (which erases all memory).
Enter the password, then type it again to confirm it and tap the OK box to save the changes. The
password is immediately in effect.
Tap the Power On checkbox to set whether the user types a password at Power On.
Tap the Screen Saver checkbox to set whether the user types a password to clear the screensaver.
If there is no screensaver chosen, this checkbox is ignored. The screensaver password affects the
Remote Desktop screensaver only.
Note: Screensavers are not installed by LXE.
Enable Password Protection
Password Settings
Password:
Confirm Password:
At Power On
Password
Password Properties
Screen Saver
Figure 3-9 Password Properties
