Control Panel Options 95
E-EQ-MX3RFIDRG-A MX3-RFID Reference Guide
Main Tab
Note: Scanner control panel options are based on the installed software version levels, driver
and OS versions in the MX3-RFID. Your Scanner options may or may not be as described
in this section. Contact your LXE representative to obtain current software and drivers
for your mobile device.
Parameter Default Options
Port 1 Internal Disabled, COM1, COM3, Internal, Cradle, Bluetooth, Output
Enable.
Port 2 RFID
Internal
Disabled, RFID Internal, COM3, Internal, Cradle, Bluetooth,
Output Enable
Power Port 1
while Asleep
Disabled Enabled, Disabled.
If “Power Port 1 while asleep” is checked, whichever serial port is
enabled as Port 1 will remain powered while the device is in
Suspend, at the cost of reduced battery life.
Send Key
Messages
Enabled Enabled, Disabled.
If “Send Key Messages …” is checked any data scan is converted
to keystrokes and sent to the active window. When this box is not
checked, the application will need to use the set of LXE Scanner
APIs to retrieve the data from the scanner driver. Note that this
latter method is significantly faster than using “Wedge”.
Adjust the settings and tap the OK box to save the changes. The changes take effect immediately.
