Control Panel Options 91
E-EQ-MX3RFIDRG-A MX3-RFID Reference Guide
Power
Access: Start | Settings | Control Panel | RFID | Power tab
Note: Control Panel parameters established in Power Properties affect the mobile device
operating system. Power Management set using RFID Configuration governs power
management of the RFID module only.
See Also: “Set the Power Schemes Timers”.
Figure 3-15 RFID Configuration Utility – Power tab
Tap the Restore Defaults button to set the parameters to their factory default setting. Tap OK to
save changes or X to ignore any changes and return to the Control Panel.
Note: MX3-RFID is restricted to 95% for Modulation. LXE recommends using the default
setting of ID2 for Class 0 Singulation.
Output Power
Provides configuration for the output power applied during Read (or Write) operations. The range
is 16 settings from +15dBm to +30dBm.
Modulation
Provides configuration carrier modulation during Read (or Write) operations. The range is from
20% to 95% in 2.42% steps.
Power Management
The time out period sets the time that the software will change the RFID module state from
Standby to Disable in order to reduce battery current consumption.
This timer expires if no reads have been requested for the specified period of time. The increments
of the timer are 3 sec., 4 sec., 5 sec., 10 sec., 15 sec., 20 sec., 30 sec., 45 sec., 1 min., 2 min., 3
min., 4 min., 5 min., 6 min., 7 min., 8 min., 9 min., 10 min., 11 min., 12 min., 13 min., 14 min.,
and 15 minutes.
When the “Disable” check box is checked, then Power Management is disabled and the RFID
module remains in the “Standby” state.
