Summit Client Configuration 133
E-EQ-MX3RFIDRG-A MX3-RFID Reference Guide
Config Tab
Note: Tap the Commit button to save changes before leaving this panel or the SCU. If the panel
is exited before tapping the Commit button, changes are not saved!
Factory Default Settings
Config Profile Default
SSID Blank
Client Name Blank
Power Save CAM
Tx Power Maximum
Bit Rate Auto
Radio Mode B+G rates
Auth Type Open
EAP type None
Encryption None
Figure 4-4 SCU – Config Tab
When logged in as an Admin (see “Admin Login”), use the Config tab to manage profiles. When
not logged in as an Admin, the parameters can be viewed, but cannot be changed.
Buttons
Button Function
Rename Assigns a new, unique name. If the new name is not unique, an error message is
displayed and the profile is not renamed.
Delete Deletes the profile. The current active profile cannot be deleted and an error
message is displayed if a delete is attempted.
New Creates a new profile with the default settings (see “Config Parameters”) and
prompts for a unique name. If the name is not unique, an error message is
displayed and the new profile is not created.
Commit Saves the profile settings made on this screen. Settings are saved in the profile.
Credentials Allows entry of a username and password, certificate names, and other
information required to authenticate with the access point. The information
required depends on the EAP type.
WEP/PSK
Keys
The Encryption type chosen determines if the WEP/PSK Keys button is active.
Allows entry of WEP keys or pass phrase as required by the type of encryption.
