44 Physical Controls
MX3-RFID Reference Guide E-EQ-MX3RFIDRG-A
Integrated Scanner Port
The integrated laser barcode scanner is used to collect barcode data from any nearby compatible
barcode label. Depending on the size of the barcode, size of bars and spacing and quality of the
barcode, the scanner is used to read barcodes between 3” and 30”. The barcode scanner reads
UPC/EAN, Code 39, Code 93, I 2 of 5, Discrete 2 of 5, Code 128, Codabar and MSI symbologies.
The integrated laser scanner scans only when the Scan button is pressed. The SCNR LED
illuminates during any mobile device integrated scanner activation.
If you need to set up the integrated scanner barcode reading parameters, please refer to
the “Integrated Scanner Programming Guide” and the “MX3” barcode scanner type. The
guide is on the LXE Manuals CD and the LXE ServicePass website.
Note: An MX3-RFID manufactured prior to July 2006 contained an SE923 barcode
scanner. The SE955 scanner replaced the SE923 scanner in devices manufactured
after July 2006. The “Integrated Scanner Programming Guide” contains both types
for scanner engine programming barcodes, default scanning ranges, barcode
reading instruction and troubleshooting.
USB Client Port
USB Client connection is made through the USB Port. The connector is an industry-standard 9-pin
“D” male connector.
The LXE USB cable is required to adapt the connection to a standard USB connector.
USB Client Cable
MX3XA069CBLD9USBCLNT
Port Label on Endcap
Mobile Device End Goes To USB Type A Plug End
1 Host Detect 1
2 Not Used
3 D + (Green Wire) 3
4 Not Used
5 Ground (Black Wire) 4
6 Not Used
7 D – (White Wire) 2
8 Not Used
9 Not Used
Figure 2-6 USB Type A to Serial Port Cable Pinout
ActiveSync
Connect from USB-C port to USB Type A Host – a laptop/desktop, etc.
