180 Wireless Zero Config Utility
MX3-RFID Reference Guide E-EQ-MX3RFIDRG-A
Wireless Zero Config Utility
Summit Client
Wireless Zero Config Icon
The WZC utility has an icon in the toolbar that looks like networked computers with a red X
through them, indicating that Wireless Zero Config application is enabled and the MX3-RFID is
not connected to a network.
LXE does not recommend use of the Wireless Zero Configuration Utility for configuring the radio
as it cannot be used to configure all supported security protocols.
You can use either the Wireless Zero Configuration Utility or the Summit Client Utility to connect
to your network.
LXE recommends using the Summit Client Utility to manage the radio.
To use Wireless Zero Config, first open the Summit Client Utility.
.
1. Select ThirdPartyConfig in the Active Config drop down box.
2. A message appears that a Power Cycle is required to make settings activate properly. Tap
OK.
3. Tap the Disable Radio button to remove the connection to the Summit Client Utility. The
text on the button changes to Enable Radio.
4. Tap the Power button to place the MX3-RFID in Suspend, then tap the Power button to
wake the MX3-RFID from Suspend mode.
The Wireless Zero Config utility begins.
