LXE E-EQ-MX3RFIDRG-A Manual

A SERVICE OF

next previous

Entering Data 23

E-EQ-MX3RFIDRG-A MX3-RFID Reference Guide

See the “Integrated Scanner Programming Guide” for scanner engine programming

barcodes, default scanning ranges, barcode reading instruction and troubleshooting.

RFID Tag Data Collection

When the RFID Read button is pressed, the reader turns on and the MX3-RFID beeps once if the

tag was located and read successfully. The reader turns off at a predetermined time limit after a

good read or a failed read.

There may be a buzz sound during the time the reader is “searching and reading” if the RFID

reader is configured to buzz during a read cycle.

See Chapter 3 “System Configuration” section titled “RFID”.

Tethered Scanner

Tethered scanners connected to an RS232 port are not supported on the MX3-RFID.

Do not connect a tethered scanner cable to a USB-C or USB-H labeled endcap port. They are

USB ports and cannot power a tethered scanner.