56 Power Supply
MX3-RFID Reference Guide E-EQ-MX3RFIDRG-A
MX3 Multi-Charger Plus Battery Charger
Note: LXE recommends that the correct MX3 Multicharger Plus always be used to charge the
main battery. The Multicharger plus label is located on the back of the device and the
charger must have been upgraded to V1.01. Please contact your LXE representative for
further information about the V1.01 upgrade kit, if needed.
The LXE Multi-Charger Plus (9000A377CHGR5US) is designed to perform two functions:
• Simultaneously charge five LXE Rechargeable Lithium Ion Battery Packs in less than four
hours.
• Simultaneously charge four LXE Rechargeable Lithium Ion Battery Packs in less than four
hours and analyze a fifth Battery Pack (ending with the battery pack fully charged) in less
than ten hours.
Figure 2-12 MX3 Multi-Charger Plus
The main battery can be charged in the MX3 Multi-Charger Plus. The main battery charges the
backup battery using the mobile device’s internal charging circuitry. The multi-charger requires an
external power source.
Figure 2-13 Insert Main Battery in Charge Pocket
Lower the battery pack straight into the battery charger pocket and push it down firmly until the
retaining clip catches on the retaining pins. The LED at the base of the charger pocket illuminates.
Refer to the MX3 Multi-Charger Plus User’s Guide for LED explanation and troubleshooting.
Do not “slam” the battery into the charging cup or slide it in sideways. Failure to follow these
instructions can result in damage to the main battery or the charger.
