Control Panel Options 81
E-EQ-MX3RFIDRG-A MX3-RFID Reference Guide
Power
Access: Start | Settings | Control Panel | Power
Set Power Off, Backlight properties. Review battery status and perform backup battery
charging/discharging.
Note: Control Panel parameters established in Power Properties affect the mobile device
operating system. Power Management settings in the RFID Configuration utility governs
power management of the RFID reader only.
Factory Default Settings
Battery N/A
Schemes – Battery Power
User Idle 3 seconds
System Idle 15 seconds
Suspend 5 minutes
Schemes – AC Power
User Idle 2 minutes
System Idle 2 minutes
Suspend 5 minutes
Please refer to Chapter 2 "Physical Description and Layout" section titled "Power Modes".
Battery
The Battery tab shows the status and the percentage of power left in the main battery (removable).
It also shows the status of the internal backup battery. The listed values cannot be changed by the
user.
Schemes
Figure 3-11 Power Schemes
Adjust the settings and tap the OK box to save the changes. The changes take effect immediately.
These mode timers are cumulative. The System Idle timer begins the countdown after the User
Idle timer has expired and the Suspend timer begins the countdown after the System Idle timer has
expired. When the User Idle timer is set to “Never”, the power scheme timers never place the
device in User Idle, System Idle or Suspend modes (even when the device is idle).
