Filter
Top Products
OCTOBER 2006 MAGNUM 1X7 LTO AUTOLOADER
77
PERFORMING DIAGNOSTIC TESTS
PERFORMING DIAGNOSTIC TESTS
To check basic autoloader functions, you can run a set of diagnostic tests from
the operator panel. These tests check the autoloader’s internal memory,
voltages, and SCSI functions. If you report a problem to Exabyte Technical
Support, you may be asked to run these tests and provide the results.
To run the autoloader’s diagnostic tests:
1.
1.1.
1. At the Home screen, press , , , or to access the main menus.
If necessary, enter the operator panel password (see page 42).
2.
2.2.
2. Press or until the Diagnostic menu appears:
3.
3.3.
3. Press to see the menu selections, then press or until the following
screen appears:
4.
4.4.
4. Press . A confirmation message appears:
5.
5.5.
5. Press to start the test (or to cancel the test).
The test begins. When the test is finished, the following screen appears:
6.
6.6.
6. Press (as needed) to return to the Home screen.
P e r f o r m a
D i a g n o s t i c
R u n h a r d w a r e
s e l f t e s t ?
S t a r t h a r d w a r e
s e l f t e s t n o w ?
H / W s e l f t e s t
p a s s e d .