Filter
Top Products
96
PRODUCT MANUAL 1012581
CHAPTER 7—MAINTENANCE
b.
b.b.
b. Carefully pull the faceplate straight off the tape drive chassis. You may
need to press the unload button to disengage it from the front of the tape
drive (see Figure 7-7).
2.
2.2.
2. Attach the brackets—Place the tape drive right side up on the work surface
(the product labels on the tape drive are on the top).
Figure 7-7 Removing the faceplate from the tape drive chassis
Unload button
!
! !
! Important
The screws are not interchangeable. The LTO-2 tape drive uses
6-32 x 1/4 pan head phillips screws; the LTO-3 uses M3 x 5.5 PH
phillips screws.
!
! !
! Tip
The embossed arrow on the
end of each bracket points up.
Arrow