Filter
Top Products
36
PRODUCT MANUAL 1012581
CHAPTER 3—CONFIGURING THE AUTOLOADER
Setting the Ethernet Addresses
To set Ethernet addresses:
1.
1.1.
1. At the Home screen, press , , , or to access the main menus.
If necessary, enter the operator panel password (see page 42).
2.
2.2.
2. Press or until the Configuration menu appears:
3.
3.3.
3. Press to see the menu selections.
4.
4.4.
4. Press or until the following screen appears:
SNMP If you are using a network-based monitor/management
application other than the autoloader’s Remote Management
utility, you may need to identify the autoloader’s Simple
Network Management Protocol (SNMP) settings to the
application. These settings include:
Read community string
Write community string
Broadcast community string
Trap address
Trap port
You can view and change these settings only through the
autoloader’s Remote Management utility. See Chapter 4 for
instructions.
FTP Interface The autoloader also includes an FTP interface that you can use
to transfer firmware files or create diagnostic listings. You can:
Set up an FTP user name and password for this interface or
use the autoloader’s defaults
View and change the FTP settings only through the library’s
Remote Management utility
For instructions, see Chapter 4.
For information about accessing the autoloader’s FTP interface
and using an FTP utility to upgrade firmware or obtain
diagnostic listings, see page 100.
C h a n g e a
C o n f i g u r a t i o n
C h a n g e I P A d d r ?
D H C P I s O N
Table 3-5 Ethernet configuration options (continued)