Filter
Top Products
OCTOBER 2006 MAGNUM 1X7 LTO AUTOLOADER
31
SETTING CONFIGURATION OPTIONS
5.
5.5.
5. Press to display the tape drive SCSI ID selection screen:
6.
6.6.
6. Press or to scroll through the available values until the one you want
appears. The default SCSI ID for the tape drive is 1.
7.
7.7.
7. Press to select the new value. A confirmation message appears:
8.
8.8.
8. Press to enact the change (or if you don’t want to make the change).
The tape drive resets and the new ID takes effect. The Configuration menu
is displayed.
9.
9.9.
9. Press (as needed) to return to the Home screen.
CHANGING THE EMULATION MODE
By default, the autoloader operates in Native emulation mode and returns the
product identification, “Magnum 1x7,” in response to a SCSI INQUIRY
command from an application. If your autoloader software has not yet been
certified for the Magnum 1x7 LTO Autoloader, you can select an option that
allows the autoloader to emulate the VXA AutoPak 1x10 autoloader, Exabyte
EZ17 autoloader, or the Exabyte 210 library. Ta b le 3 -4 lists the available
emulation modes for the autoloader.
To change the emulation mode:
1.
1.1.
1. At the Home screen, press , , , or to access the main menus.
If necessary, enter the operator panel password (see page 42).
S e l e c t S C S I I D
N e w D r i v e I D n
S e t D r i v e I D
t o n n o w ?
Table 3-4 Emulation modes for the Magnum 1x7 LTO Autoloader
Emulation Mode Returns this Product Identification in response to an INQUIRY command
Native 2-U The default Product Identification stored in the autoloader’s microcode.
AutoPak 110 “VXA_AutoPak_1x10” where each “_” represents an ASCII space character.
Exabyte EZ17 “Exabyte EZ17_ _ _ _” where each “_” represents an ASCII space character.
Exabyte 210 “EXB-210_________” where each “_” represents an ASCII space character.