Filter
Top Products
12
PRODUCT MANUAL 1012581
CHAPTER 2—INSTALLING THE AUTOLOADER
To install the library in a rack, you must obtain these tools:
ASSEMBLING THE RAILS
1.
1.1.
1. Measure the depth of your rack—Using a tape measure, measure the inside
distance from the front mounting holes of your rack to the back mounting
holes. See Figure 2-5, distance (E).
2.
2.2.
2. Position the front and back sections of the left-side rail as shown in
Figure 2-3, with the front rail section on top of the back rail section. Spread
the sections to the distance you measured in step 1.
3.
3.3.
3. Assemble the left rail using four M5 screws. Keep the screws loose so that
you can adjust the length of the assembled rail, if necessary.
#2 Phillips screwdriver Level Tape measure
Figure 2-3 Assembling the left-side rail
Left-side rails (viewed from front)
Front
Back
Front
section
flange
section
M5 screw
(black)
Small back flange
(attach the library
here in final step)
Back flange
Front
Back