Filter
Top Products
OCTOBER 2006 MAGNUM 1X7 LTO AUTOLOADER
29
SETTING CONFIGURATION OPTIONS
5.
5.5.
5. Press to display the contrast selection screen:
6.
6.6.
6. Press or to scroll through the available values until the one you want
appears. The contrast changes as you press the button.
7.
7.7.
7. Press to select the new value. A confirmation message appears:
8.
8.8.
8. Press to enact the change (or if you don’t want to make the change).
9.
9.9.
9. Press (as needed) to return to the Home screen.
CHANGING THE SCSI IDS
Each device on a SCSI bus must have a unique SCSI ID so that it can be
identified by the host computer. The autoloader and the enclosed tape drive
use separate IDs on the same SCSI bus so that they can receive different sets of
commands. You can use the default IDs or change them if they conflict with
other devices on the SCSI bus.
Note: If you change the autoloader or tape drive’s SCSI ID after the autoloader
has been in operation, you may need to reboot your host computer so that
it recognizes the new ID.
Autoloader SCSI ID
To change the autoloader’s SCSI ID:
1.
1.1.
1. At the Home screen, press , , , or to access the main menus.
If necessary, enter the operator panel password (see page 42).
2.
2.2.
2. Press or until the Configuration menu appears:
3.
3.3.
3. Press to see the menu selections.
S e l e c t C o n t r a s t
N o w : n n
S e t c o n t r a s t t o
n n n o w ?
C h a n g e a
C o n f i g u r a t i o n