Filter
Top Products
114
PRODUCT MANUAL 1012581
CHAPTER 9—SHIPPING THE AUTOLOADER
REMOVING THE AUTOLOADER FROM THE RACK
If the autoloader is installed in a rack, remove it as described below.
1.
1.1.
1. From the back of the rack, use a #1 Phillips screwdriver to remove the two
screws that secure the autoloader to the rails (see Figure 9-1). Save the
screws.
2.
2.2.
2. From the front of the rack, slide the autoloader forward and out of the rack
(see Figure 9-2).
!
! !
! Important
Do not ship the rack-mounting hardware if you are returning the
autoloader for service.
Figure 9-1 Removing the screws securing the autoloader to the rails
Figure 9-2 Removing the autoloader from the rack
Remove this screw
(one each side)