Filter
Top Products
440
S:\agilent\8920\8920b\PRGGUIDE\BOOK\CHAPTERS\callproc.fb
Chapter 8, Programming the Call Processing Subsystem
Programming the CALL CONTROL Screen
Active
This field is used to turn on the forward control channel of the Test Set or to force
a return to the
Active state from any other state (Register, Page, Access,
Connect).
If the forward control channel of the Test Set is already active, sending the
:ACTive command will deactivate and then reactivate the control channel.
The :ACTive command is used to control this field.
There is no query form of the :ACTive command.
Syntax
:ACTive
Example
OUTPUT 714;"CALLP:ACT"
[] Active
When lit, the Active annunciator indicates that the control channel of the Test
Set is turned on.
If this annunciator is lit, the Base Station is transmitting system parameter
overhead messages on the assigned control channel. If the annunciator is not lit
the base station is not active (note that the Test Set may still be outputting a
modulated RF carrier but the Test Set’s firmware is not active and no
communication can occur between a mobile station and the Test Set).
The
Active annunciator is not programmable.
The state of the
Active annunciator is reflected in the Call Processing Status
Register Group Condition Register bit 0. See “Status Reporting” in the User’s
Guide for further information.