Filter
Top Products
191
Equivalent Front-Panel Key Commands
To Set the Increment Value Display Units. Use the :INCRement:DUNits
commands to set the units-of-measure used to display the increment value. Refer
to
“Display Units (DUNits)” on page 75 for description of Display Units.
Syntax
:INCRement:DUNits <disp_units>
Example
OUTPUT 714;"RFG:FREQ:INCR:DUN KHZ"
This sets the increment value’s Display Units to kHz for the RF
Generator’s frequency.
NOTE: When querying a field setting through GPIB, the Test Set always returns numeric values in
GPIB Units or Attribute Units, regardless of the field’s current Display Units setting.
Numeric values are expressed in scientific notation. Refer to “Attribute Units (AUNits)”
on page 81 and “GPIB Units (UNITs)” on page 78.
To Query the Increment Value Display Units.
Use the :INCRement:DUNits?
commands to query the units-of-measure used to display the increment value.
Refer to
“Display Units (DUNits)” on page 75 for description of Display Units.
Syntax
:INCRement:DUNits?
Example
OUTPUT 714;"RFG:FREQ:INCR:DUN?"
ENTER 714;Disp_unit$
This queries the increment value’s Display Units for the RF Generator’s
frequency.